- Svježe
PLA Filament 1,75mm, 3D filament pisača, PLA 3D filament pisača, 3D ispis niti, dimenzionalna tačnost,
Visoka preciznost : Tolerancija promjera žice nalazi se na 0,03 mm, što ne izaziva nedovoljnu ekstruziju niti priključak Mnogo snage : visoko u zateznoj čvrstoći, duktilnosti i žilavosti, takođe nisko u skupljanju i težini fluidnosti. Dobar ispis : Osiguravanje ne-divljači niti mjehurića, oblikovanje je glatko i osjetljivo s preciznim bojama. Čisti materijal : izrađen od plastičnog materijala sa visokom čistoćom, ima dobru fleksibilnost i otpornost za ispis. Praktična upotreba : Primijenite filament na 3
D štampač, lako možete stvoriti raznovrstan meki i tvrdi proizvod. Specifikacija : PLA Filament
Material : plasticphysical Propertsies
Tandard Vrijeme metoda
Density1,24 / cm³astm d-792mfr (190 ℃, 8,7kg) 1,8 g. (190 ℃, 8,7kg) 1,8 g (190 ℃, 8,7kg) 1,8 g (190 ℃, 8,7kg) 0,30% ASTM D570
Mechanic Propees
Ten
Standar
D48,5
MPaastm D638
Bejdming82 .7
MPAASTM D790
Notched udara (Izod, 23 ℃) 16kgj / Mast
M D256
Elongacija na raspustu≥2,5% ASTM D638
Distortion Temperatura 03.75mm / 0,07in) 1,75 ± 0,03 mmq / jht001-2014rounds brijanje≤0.03mmq / JHT001-2014 Lista paketa : 1 x PLA Filament Napomena : Temperatura glave ekstrudera pisača mora se kontrolirati na 190-210 ℃, a nosač za potporu ne treba zagrejati. Nakon što se linije suše u 50 ℃ za 2-4 sata, efekt oblikovanja bit će bolji.
Karakteristike
- Item Type:
- PLA Filament
- Material:
- PlasticPhysical PropertiesStandard ValuesTest MethodDensity1.24g/cm³ASTM D-792MFR(190℃, 8.7Kg)1.8g/10minASTM D1238Water Absorption (Saturated, 23℃)0.30%ASTM D570Mechanical PropertiesStandard ValuesTest MethodTensile Strength48.5MPaASTM D638Bending Strength82.7MPaASTM D790Notched impact strength (IZOD, 23℃)16Kgj/mASTM D256Elongation at Break≥2.5%ASTM D638Distortion Temperature60℃ASTM D648AccuracyStandard ValuesTest MethodDiameter (Approx. 1.75mm / 0.07in)1.75±0.03mmQ/JHT001-2014Roundness Deviation≤0.03mmQ/JHT001-2014
- Package List:
- 1 x PLA Filament
- Note:
- The temperature of the printer's extruder head must be controlled at 190‑210℃, and the support plate does not need to be heated. After the lines are dried at 50℃ for 2‑4 hours, the moulding effect will be better.